............................................................................................................................................................................................................................................................

Create head/tail pseudowire

Purpose

Use this procedure to manage a new Head/Tail Pseudowire.

Select (T)MPLS -> PseudoWire Management from the menu bar as shown in

Figure

Click Create Head/Tail Pseudowire to configure and new Head/Tail Pseudowire as

shown in

Figure 5-81 Pseudowire management

Table 5-45

Segment parameters:

Table 5-45 Pseudowire segment parameters

Parameter

Port

Type

Direction

In Label

PHB Profile

Primary State

5 - 10 8

5-81.

Figure

5-81.

"Pseudowire segment parameters"

provides the description of Pseudowire

Description

Specifies the AID of the provisioned port or Tunnel Segment

Specifies the type of Pseudowire Segment. In this case, it is

always TERMINATION

Specifies the Pseudowire Segment direction. The values are

BIDIR, UNIDIRIN, and UNIDIROUT

Specifies the expected Label for incoming segment

associated to Sink Pseudowire Segment. The parameter is

not relevant if DIR=UNIDIROUT. The label value must be

unique in the system. The valid range is 1024-1048575

Specifies the AID of PHB Profile resource

Specifies the primary state, IS/OOS. The default is IS

Create head/tail pseudowire

8DG08763KAAA

Issue 1 February 2009

Table of Contents

Chapters

Table of Contents

This manual is also suitable for:

Tss-320 Tss-160

Create Head/Tail Pseudowire; Pseudowire Segment Parameters - Alcatel-Lucent 1850 User Provisioning Manual