Alcatel-Lucent 1850 User Provisioning Manual page 159

Menu bar
............................................................................................................................................................................................................................................................
Cyclic Redundancy Check - it indicates the 8-digit hexadecimal value of the 32-bit
•
Cyclic Redundancy Check stored on the backup media.
Remote file
This menu option contains the following three choices:
Perform Copy - It copies secondary backup database on the NE from/to specified
•
locations on a Remote File Server (RFS)
Cancel Copy - It interrupts an in-progress file transfer previously initiated
•
File Information - It is used to read information related to transferred files on a
•
Remote File Server
Perform copy
Only one of this option can be active on an NE at any given time. This option initiates the
file upload/download operation and returns a complete response once the operation has
been verified as possible and initiated. During the subsequent file transfer, the answers are
generated every 30 seconds (+/- 15 seconds) to indicate the percentage of completion of
the file transfer and the final completion status. During the transfer period, a Cancel Copy
option can be used to abort the operation.
The command is used for data base transfer operations to and from remote devices (RFS)
located in an IP-based DCN (Data Communication Network) via the ftp File Transfer
Protocol.
Remote database backup - This option can be used to accomplish a remote database
•
backup. After creating a local backup of the primary backup database into the
secondary backup database, the secondary backup database can be transferred to the
RFS. A remote database backup request is denied if no valid secondary backup
database exists on the system. (E.g., no database backup command was successfully
performed before.)
Remote database restoration - This option can be used to accomplish a remote
•
database restore. After transferring an RFS DB to the secondary backup database on
the system, the secondary backup database can be activated via the Restore Database
option.
When an RFS DB is copied to the secondary backup database, the system makes sure that
the directory path indicated in the Location parameter exists on the RFS. If it doesn't, the
operation fails.
The operation verifies the system type, software release identifier, time stamp and SID of
the system against the information stored in the RFS backup. A copy operation with a
system type mismatch cannot be performed.
A copy operation cannot be performed unless the Command Mode parameter is set to
Forced.
with a software release identifier mismatch
•
with a SID mismatch
•
............................................................................................................................................................................................................................................................
8DG08763KAAA
Issue 1 February 2009
System management menu
3 - 9 3