Alcatel-Lucent 1850 User Provisioning Manual page 488

Appendix
............................................................................................................................................................................................................................................................
Figure 6-18 Line facility (STMn) provisioning state transitions
Other Secondary States
1. SDEE shall be set when supported facilities are created.
2. SGEO shall be set when the supporting IOC is OOS for any reason; SGEO shall
3. TRM shall be set if a supported facility is connected
4. LPBK shall be set if a loopback is present on this facility
5. PMI shall be set if performance monitoring is inhibited on this facility
6. PSI shall be set if protection switching is locked out
7. STBYH shall be set if this is the alternate facility in a Linear FFP and not currently
8. STBYS shall be set if this is standby preferred facility in a linear FFP and not
9. WRK shall be set if this facility is a member of a UPSR FFP or if it is the working
10. When a port that can be provisioned for more than one OC rate is provisioned for
11. A facility that is entered with failure will first pass to OOS-MA or IS, then to
e
Other Secondary States
SDEE shall be set when supported facilities are created.
•
............................................................................................................................................................................................................................................................
6 - 94
clear FAF while set
active
currently active
side of a Linear FFP
one rate, the facilities for the other rates return to DSBLD state.
OOSAU, FAF after the failure integration period, normally 2.5 seconds
Facility state transitions
8DG08763KAAA
Issue 1 February 2009