Adjusting The Control Handle Neutral Position - Toro Diesel Z Master Service Manual

2. Start the engine and run it at low idle speed. Engage
the motion control lever on one side and spin the
wheel by hand (Fig. 324).
Fig 324
3. When the wheel begins to spin on its own, keep it
engaged until the wheel drives smoothly (minimum 2
minutes).
4. Check the hydraulic fl uid level in the reservoir and
add as required to maintain proper level.
5. Repeat this procedure on the opposite wheel.
Z580/Z593/Z595 Diesel Service Manual
HYDRAULIC SYSTEM
Adjusting the Control Handle Neutral
Position
If the motion control levers do not align or do not move
easily into the console notch, adjustment is required.
Adjust each lever, spring and rod separately.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the seat (Fig. 325).
PICT-3465a
Fig 325 PICT-3469
4
4-25