Table of Contents
Advertisement
Motion Control Damper Replacment
There is a right and a left motion control damper. The
following removal and installation procedures are done
on the right damper. The procedures are the same for
the left damper.
Motion Control Damper Removal
1. Park the machine on a level surface, disengage the
PTO, turn the ignition off and remove the key.
2. Raise the seat.
3. Remove the negative battery cable from the battery.
4. Remove the outer nut from the bolt on the lower end
of the damper (Fig. 229).
Fig 229
Z580/Z593/Z595 Diesel Service Manual
5. Remove the outer nut from the bolt on the upper end
of the damper (Fig. 230).
6. Remove the damper assembly (Fig. 231).
PICT-3171
CHASSIS
Fig 230
PICT-3173
Fig 231
PICT-3178
3
3-61
Advertisement
Table of Contents
