Controls System Maintenance; Adjusting The Control Handle Neutral Position - Toro Z Master Professional 7000 Series Operator's Manual

Figure 95
1. Alternator
2. Alternator belt
3. Deflection, 7 to 9 mm (1/4
to 11/32 inch) with 10 kgf
(22.1 lb of force)
g000968
4. Top bolt
5. Bottom bolt
Controls System
Maintenance
Adjusting the Control
Handle Neutral Position
If the motion-control levers do not align, or move
easily into the console notch, adjustment is required.
Adjust each lever, spring and rod separately.
Note:
The motion-control levers must be installed
correctly.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Unlatch the seat and tilt the seat forward.
4. Begin with either the left or right motion-control
lever.
5. Move the lever to the neutral position but not
locked (Figure
6. Pull the lever back until the clevis pin (on arm
below pivot shaft) contacts the end of the slot
(just beginning to put pressure on the spring)
as shown in Figure
7. Check where the control lever is relative to notch
in console (Figure
Note:
It should be centered, allowing lever to
pivot outward to the N
1. N - position
EUTRAL LOCK
2. Control lever
8. If adjustment is needed, loosen the nut and jam
nut against the yoke
65
96).
96.
96).
- position.
EUTRAL LOCK
Figure 96
3. N position
EUTRAL
(Figure 97).
g001046