Toro Diesel Z Master Service Manual page 113

HYDRAULIC SYSTEM
4. Begin with either the left or right motion control lever.
5. Move the lever to the neutral position but not locked
(Fig. 326).
C
4
A. Neutral locked position
B. Control lever
6. Pull the lever back until the clevis pin (on arm below
pivot shaft) contacts the end of the slot (just begin-
ning to put pressure on the spring) (Fig. 326).
7. Check where the control lever is relative to the notch
in console (Fig. 326). It should be centered with the
neutral lock notch, to allow lever to pivot outward to
the neutral lock position.
4-26
B
A
Fig 326 fi g. 62 G001046
C. Neutral position
8. If adjustment is needed, loosen the nut and jam nut
against the yoke (Fig. 327).
Fig 327
A. Height-of-cut lever
B. Nut against yoke
C. Jam nut
D. Clevis pin in slot
9. Apply slight rearward pressure on the motion con-
trol lever, turn the head of the adjustment bolt in
the appropriate direction until the control lever is
centered in the neutral lock position (Fig. 327).
Note: Keeping rearward pressure on the lever will
keep the pin at the end of the slot and allow
the adjustment bolt to move the lever to the
appropriate position.
10. Tighten the nut and jam nut (Fig. 327).
11. Repeat procedure for the opposite control handle.
Z580/Z593/Z595 Diesel Service Manual
A
D
F
B
C
G
E
fi g. 63 G001155
E. Adjustment bolt
F. Yoke
G. Spring