HYDRAULIC SYSTEM
13. Install a cotter pin into the wheel motor shaft (Fig.
322).
4
14. Install the rear wheel.
15. Install the negative battery cable.
16. Lower the seat.
4-24
Fig 322
PICT-3350
Purging the Hydraulic System
The hydraulic system is normally self-bleeding however;
it may be necessary to bleed the system if fl uid is
changed, or after work is performed on the system.
1. Raise rear of the machine so the wheels are off the
ground and support it with jack stands (Fig. 323).
Fig 323
Z580/Z593/Z595 Diesel Service Manual
PICT-3464