Toro Diesel Z Master Service Manual page 96

3. Repeat steps 1 and 2 to install the other control arm
to the opposite pump control shaft.
4. Position the pump mounting bracket to the pump.
Loosely install 2 bolts, washers and nuts securing
the pump mounting bracket to the pump (Fig. 268).
Fig 268
5. Lower the mower deck to the lowest height-of-cut
position.
6. From under the machine, position the pump input
shaft through the hole in the frame (Fig. 269).
Fig 269
Z580/Z593/Z595 Diesel Service Manual
HYDRAULIC SYSTEM
7. Align the pump mounting bracket to the frame and
loosely install 2 bolts, washers and nuts (Fig. 270).
PICT-4204 8. Position the pump shield plate over the pump shaft,
against the frame. Install 2 two bolts, washers and
nuts securing the pump shield plate and pump to the
frame (Fig. 271).
PICT-3309
Fig 270 PICT-3312
Fig 271 PICT-3257
4
4-9