Hydrostatic Tandem Pump Installation - Toro Diesel Z Master Service Manual

HYDRAULIC SYSTEM
33. Remove the set screw securing the control arm to
the pump control shaft. Remove the control arm from
the pump control shaft (Fig. 264).
4
34. Repeat steps 29 and 30 to remove the opposite
control arm from the pump.
35. For tandem pump service, refer to the Hydro-Gear
P Series Pumps Service and Repair Manual (form
BLN-52503)
36. Transfer all fi ttings and markings to the new hydro-
static tandem pump (Fig. 265).
4-8
Fig 264 PICT-3302
Fig 265 PICT-3305a

Hydrostatic Tandem Pump Installation

1. Apply thread locking compound to the pump control
arm set screw (Fig. 266).
Fig 266
2. Thread the set screw into the control arm. Slide a
control arm onto the pump control shaft and tighten
the set screw (Fig. 267).
Fig 267
Z580/Z593/Z595 Diesel Service Manual
PICT-3307a
PICT-3302