Toro Diesel Z Master Service Manual page 116

12. Start the engine, open the throttle 1/2 way and
release the parking brake.
13. Adjust the pump rod length by rotating double nuts
on rod, in the appropriate direction, until wheel is still
or slightly creeps in reverse (Fig. 334).
Note: The front nut on the pump rod has left-hand
threads.
Fig 334
14. Move the motion control lever forward and reverse,
then back to neutral. The wheel must stop turning; it
is acceptable to have a slight creep in reverse.
15. Open the throttle to Fast. Make sure the wheel re-
mains stopped or slightly creeps in reverse; adjust if
necessary.
Z580/Z593/Z595 Diesel Service Manual
HYDRAULIC SYSTEM
16. Tighten the jam nuts at the ball joints (Fig. 335).
17. After both pump neutrals are set, shut off the
machine.
18. Remove the jumper wire from the wire harness ter-
minals and plug the terminals into the seat switch
PICT-3489a
(Fig. 336).
19. Install the seat rod and lower the seat into position.
20. Lower the machine.
Fig 335 PICT-3486a
Fig 336 PICT-3491a
4
4-29