Toro Diesel Z Master Service Manual page 274

Note: Install the pulley so that the hub is .06"
(1.5mm) from the end of the gearbox driven
shaft. Tighten the set screws (Fig. 873).
Fig 873
8. Torque each set screw to 145 + 20 in-lbs. (16 + 2.25
Nm) (Fig. 874).
Fig 874
Z580/Z593/Z595 Diesel Service Manual
9. Position the gearbox assembly to the frame (Fig.
875).
PICT-3925
10. Install 4 mounting bolts and lock washers securing
the gearbox assembly to the frame. Torque the 4
mounting bolts to 145 + 20 in-lbs. (16 + 2.25 Nm)
(Fig. 876).
PICT-3927a
MOWER DECKS
Fig 875
Fig 876
PICT-3898
7
PICT-3930
7-51