Table of Contents
Advertisement
Note: Non-commercial owners will need to loosen
the seat retainer clip that holds the seat in place.
2. Check the belt for wear and replace it if needed.
3. To replace the belt, remove the bolt from the clutch
stop and unplug the clutch electrical wire (Figure 45).
4. Pull on the idler pulley to relieve the belt tension on
the idler pulley (Figure 45).
5. Remove the pump drive belt from the engine and the
hydraulic pump pulleys (Figure 45).
6. Install the new belt around the engine and the
hydraulic pump pulleys (Figure 45).
7. Pull the spring-loaded idler to the side and align the
belt.
8. Release the pressure on the spring loaded idler
(Figure 45).
Figure 45
1. Belt
2. Transmission pump
pulleys
3. Engine pulley
4. Spring loaded idler pulley
Controls System
Maintenance
Adjusting the Control Handle
Neutral Position
1. Disengage the PTO, move the motion control levers
to the neutral locked position, and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Loosen the bolts and curved washers installed in the
levers (Figure 46).
4. Align the levers front to rear position by bring the
levers together to the neutral position and slide
them until they are aligned, then tighten the bolts
(Figure 47).
36
Figure 46
Advertisement
Table of Contents
