Electric Pto Clutch Installation Ogura Clutch - Toro Diesel Z Master Service Manual

MOWER DECKS
12. Remove the key from the stub shaft (Fig. 833).
13. Remove the clutch adapter from the stub shaft (Fig.
834).
7
7-40
Fig 833 PICT-3955
Fig 834 PICT-3954a
Electric PTO Clutch Installation
Ogura Clutch
1. Insert a 0.015"–0.021" (0.381–0.533mm) feeler
gauge through one inspection slot in the side of the
electric PTO clutch. Make sure it is between the
armature and the rotor friction surfaces (Fig. 54).
2. Tighten the lock nuts until there is slight binding on
the feeler gauge but it can be moved easily within
the air gap (Fig. 835).
A
C
Fig 835
A. Slot
B. Adjusting nut
3. Repeat this for the remaining slots.
4. Check each slot again and make slight adjustments
until the feeler gauge fi ts between the rotor and
armature with very slight contact between them.
Z580/Z593/Z595 Diesel Service Manual
A
B
fi g. 54 G007168
C. Feeler gauge