Adding The Comparison Results; Main Display Comparison Function - A&D GF-30K Instruction Manual

10-8-3.

Adding the Comparison Results

By setting the "Comparison results (
can be added to the data output using the RS-232C serial interface. Use A&D standard
format ( ). The AD-8121B printer can not be used.
type 0
The comparison results are added after the header in A&D standard format as below.
Header
Comparison result
10-8-4.

Main Display Comparison Function

The main display comparison function displays the comparison results in a magnified way,
on the main portion of the display in place of the weight value.
Selecting a unit
Step 1 Press the
Note While the main display comparison function is in use, unit selection using
MODE
the
Setting the function table
Step 2 Press and hold the
then release the key.
Step 3 Press the
Step 4 Press the
Step 5 Press the
Step 6 Press the
Note To disable the main display comparison function, set the "Main display
comparison (Cp-b)" parameter to "0".
Step 7 Press the
Step 8 Press the
Setting the comparator values
Setting the comparator values as described in the previous section.
This example uses
Using the main display comparison function
Step 1 Press the
Step 2 Place a sample on the pan. The balance performs a comparison using the specified
comparison values and displays the comparison results, HI, OK or LO.
Cp-r
Data
When the comparison result is HI
When the comparison result is OK
When the comparison result is LO
Not applicable
key to select a unit to be used for comparison.
MODE
key is not available.
SAMPLE
key several times to display
SAMPLE
key.
PRINT
key several times to display
SAMPLE
key to display
RE-ZERO
key to store the setting.
PRINT
key to return to the weighing mode.
CAL
(Continuous comparison, excluding "near zero").
Cp 3
key to set the display to zero.
RE-ZERO
)" of the function table to "
Unit Terminator
key until of the function table is displayed,
ba5fnc
.
Cp-b 1
50
", the comparison results
1
.
Cp fnc
Cp-b 0 .