Entering The Password Before Weighing - A&D BM series Instruction Manual

Entering the Password Before Weighing

15.4.
pA55 1 (Entering a password is required before starting weighing)
15.4.1.
1 In the standby mode, press the
2 After
PA55 WD ,
U5ER
you to enter a password.
3 Enter a four-digit password using the following keys.
The display will turn off automatically after ten minutes of
non-operation.
key.............To enter
MODE
key...........To enter
RANGE
key.............To enter
PRINT
key........To enter
RE-ZERO
key ................To go back one character
CAL
4 When the password is correct, the balance
displays the login level, turns all the display
segments on, and then enters the weighing mode.
When the administrator password is entered, you
are logged in as an administrator.
The default password set at the factory is
(press the
RE-ZERO
administrator level.
When the password is incorrect, the balance
displays , sounds the buzzer three times
FA iL
and turns the display off.
Note When the balance software version is 1.50 to 1.64,
the login level is not displayed when logged in.
When the balance software version is 1.660 or later,
enter the administrator password to log in as an
administrator.
key.
ON:OFF
is displayed to prompt
PA55
----
m
r
p
2
2222
key four times), for
Enter four characters
Correct
password
LoG
In : ADMIN
Login level
Full segments
0.0000
Weighing mode
78
U5ER
PA55 WD
PA55
----
RANGE
PA55
No operation
2222
for 10 minutes
Incorrect
password
FA iL
Display off
BM series