Table of Contents
Advertisement
DUPLEX UNIT
8.6.3 Side-to-side Registration Adjustment (copier with RDH and
Finisher)
If the side-to-side image registration for paper fed from the duplex tray should
be adjusted, follow the entire procedure below.
If the side-to side registration for duplex tray feed does not need to be
adjusted but side-to-side registration for the paper feed tray should be
adjusted, follow only steps 4 and 5 of the procedure below.
[C]
1. Enter SP mode (refer to the service program access procedure) and
access the side to side registration adjustment mode (
Adjustment - PAGE 4).
2. Adjust side-to-side registration for the duplex tray by changing the SP
mode data.
NOTE: Copies can be made in SP mode. Touch "Copy in SP" key to
select the paper feed station.
Adjustment standard: Less than ± 2 mm difference between
3. Change the SP data of each paper feed tray so that it is the same as the
SP data of the duplex tray.
4. Loosen the screws [A] for the tandem tray or built-in LCT, [B] for universal
tray, or [C] for by-pass feed tray.
5. Reposition the tray by moving parts [D], [E] and [F] of the trays.
[A]
A176R703-2.wmf
[F]
A176R705-2.wmf
original and copy.
5-120
[D]
8 July 1996
[B]
[E]
A176R704-2.wmf
SP
Advertisement
Table of Contents
