Table of Contents
Advertisement
15 July 1996
28. Enter SP mode as follows:
1) Press the clear modes key.
2) Enter "107".
3) Press the clear/stop key for more than 3 seconds.
29. Press the "SP Adjustment" key [A].
30. Press the "Start" key [B] of
the developer initial setting.
NOTE: Developer initial setting stops automatically.
31. Press the "Index" key [C].
32. Press the "Quit" key [D] to exit SP mode.
NOTE: If the developer initial setting is not completed, you cannot exit
the SP mode by pressing the "Quit" key. If this occur, turn off and
on the main switch then repeat steps 27 to 31 again. If the result
is the same, see the troubleshooting section "SC352" (Page 6- 9).
[A]
[B]
3-11
COPIER INSTALLATION
A176I515.img
A176I516.img
[D]
[C]
Advertisement
Table of Contents
