Table of Contents
Advertisement
OPTICS
2.8 SCANNER CONTROL ADJUSTMENT (except for 70 CPM
version)
[B]
Perform this adjustment under any one of the following conditions:
After the scanner motor replacement
After the scanner wire replacement
After the scanner timing belt replacement
After replacing the optics control Board
1. Perform the free run (
2. After the free run is completed, turn the rotary dip switch [A] until LED 501
[B] turns on.
NOTE: If this adjustment is improper, the timing between the scanner
and the paper feed will be also improper, causing paper jams at
the registration roller, or causing scanner noise due to wire
vibration.
LED 501
Test Mode - PAGE 1) 30 times.
5-32
15 July 1996
[A]
A176R552.wmf
Advertisement
Table of Contents
