Table of Contents
Advertisement
15 July 1996
4
SP SPECIAL FEATURES
PAGE 2
Item
Enables user code mode.
* See the note below.
Enables the PM alarm.
Selects the PM alarm interval after the
counter was cleared (using
Counter Clear - PAGE 1)
NOTE: 1) To enable user code mode, perform the following procedure.
2) When
already entered.
1. Register at least one user code by using user tool No. 8.
2. Enter SP mode then enable the user code mode by selecting
3. Turn off the main switch.
4. Remove the plastic cap [A] on the right upper cover.
5. Disconnect the key counter short-circuit connector [B].
6. Return the plastic cap [A].
7. Turn on the main switch and check the operation.
A176M529.img
Function
PM
is selected, at least one user code should have been
4-25
SERVICE PROGRAM MODE
A176M568.wmf
Setting
Enable
Disable
Enable
Disable
[B]
[A]
Default
120 k
.
Advertisement
Table of Contents
