Table of Contents
Advertisement
OPTICS
- INSTALLATION -
[A]
1. Round the rear scanner drive wire on the rear pulley as follows:
1) Align the cut out [A] on the edge of the rear drive pulley and the blue
mark [B] on the wire as shown.
2) Round the wire counterclockwise 5 times as shown (in the illustration,
the D-cut [C] on the shaft is at the front side) then set the bead [D] on
the wire in the hole [E] on the pulley.
(In this condition, the bead just reaches the hole on the pulley.)
3) After setting the bead in the hole, round the wire two more times (in
total 7 times).
4) Fix the wire with tape [F] as shown.
[B]
[E]
[C]
[D]
A176R537.wmf
5-22
15 July 1996
[F]
Advertisement
Table of Contents
