Table of Contents
Advertisement
SERVICE PROGRAM MODE
1
SP ADJUSTMENT
PAGE 3
Item
Changes the ON timing of the registration
clutch (0.5 mm/step).
Changes the OFF timing of the erase
lamp to adjust the leading edge erase
margin (0.5 mm/step).
Adjusts magnification in the paper feed
direction by adjusting the scanner motor
speed (0.1%/step).
Adjusts magnification perpendicular to
the direction of the paper feed. The lens
position in the full size mode is changed
(0.1%/step).
Adjusts the lens horizontal stop position
for each paper feed section
(0.1 mm/step).
Adjusts the lens horizontal stop position
to compensate for variations in the side
to side positioning of the original.
A176M504.img
Function
PAGE 4
Adjustment standard: 0 ± 2 mm
Adjustment standard: 3.5 ± 2.5 mm
Perform this adjustment when the optic
control PCB has been replaced.
Adjustment standard: 100 ± 1%
Perform this adjustment when the optic
control PCB has been replaced.
Adjustment standard: 100 ± 1%
Refer to "8.6.2 Side-To-Side Registration
Adjustment" in Section 5.
4-10
15 July 1996
A176M505.img
Note
Advertisement
Table of Contents
