Table of Contents
Advertisement
15 July 1996
4. Adjust the Auto off timer following
the instructions on the display.
•
Time can be adjusted from 1 to
120 minutes in 1 minute steps.
•
You cannot cancel the Auto off
mode. The [OFF] key cannot
be selected.
5. To return to the User Tools Menu,
touch the [Menu] key.
6. To exit from the User Tools
condition, touch the [Exit] key.
10.1.2 Duplex Default Mode
NOTE: There is an explanation of the Duplex mode in your Operating
Instructions. The explanation of the Duplex mode described below is
a supplement/correction of that given in your Operating Instructions.
The factory (Default) setting in Menu 5 (Set operation modes) of the User
Tools has been set at "PROGRAM 5" rather than "NORMAL". This allows
copy modes stored in Program 5 be set as the default. (For detail, refer to
Page 16 of your Operating Instruction Book.)
To save paper resources, the following Duplex mode has been selected as
the factory (default) setting using Program 5;
•
Copiers with the document feeder and the sorter stapler are set for two
sided copies from an even number of originals.
•
Copiers with the recirculating document handler and the finisher are set
for two sided copies from one sided originals.
Canceling The Duplex Default Mode
To cancel the Duplex Default mode,
store one-sided copy mode in Program
5 as follows:
1. Press the Clear Modes key.
2. Touch the [Duplex/Series Copies]
key to cancel the duplex mode.
Note: The illustration on the right shows
display for the document feeder
and the sorter stapler system.
ENERGY SAVING INFORMATION
2-111
A176D646.img
A176D647.img
Advertisement
Table of Contents
