Table of Contents
Advertisement
15 July 1996
[F]
[D]
[A]
[E]
[G]
8. Open the front door of the finisher and remove the screw [A] fixing the
locking lever [B], then lower the locking lever.
9. Stick the cushions [C] (middle), [D] (short), [E] (long) as shown.
NOTE: Stick the cushion [C] on the metal stay (not on the cover).
Align the upper edge of the cushion [D] with the edge of the
stay [F].
Align the lower edge of the cushion [E] with the edge of the
stay [G].
10. Install the relay guide [H] (2 screws).
11. Secure the protective earth wire [I]* (1 screw) and the wire [J] (1 screw).
*NOTE: For all models other than those intended for North America, the
green wire is meant to be used as a functional earth and should
be connected as shown.
12. Connect the fiber optics connector [K] and the 4P connector [L].
13. Align and press the finisher against the copier and fix them by raising the
locking lever [B].
NOTE: At this time, confirm that the mylar [M] is located between the
guides [N].
14. Secure the locking lever (1 screw).
[B]
[N]
A608I506.img
[C]
[K]
[L]
[N]
[I]
[M]
A608I507.wmf
3-39
FINISHER (A608)
[J]
A608I505.wmf
A608I510.wmf
[H]
Advertisement
Table of Contents
