Table of Contents
Advertisement
15 July 1996
[B]
3. Install the cover [A] with the screw (if necessary). The cover and screw
are supplied as an accessory with the copier.
4. Install two stepped screws [B].
NOTE: There is one screw hole on the left side for the stepped screw.
However, there are two screw holes on the right where the
stepped screw is to be installed. Install the stepped screw into
the inner screw hole [C], as shown in the illustration.
5. Mount the DF to the copier [B] by inserting the screws into the holes of
the DF hinge [D], then slide the DF to the front as shown.
6. Secure the DF to the copier by using the screw hole as shown
(2 screws - M 5 x 10 [E]).
[B]
[D]
A610I512.wmf
3-25
DUAL JOB FEEDER (A610)
[A]
[B]
[C]
A610I511.wmf
[E]
A610I513.wmf
Advertisement
Table of Contents
