Table of Contents
Advertisement
PAPER FEED
[A]
5. Re-install the by-pass paper size sensor then reassemble the by-pass
feed table.
NOTE: When installing the table assembly, route the wires [A] correctly
as shown.
The paper guides [B] must be in the lower position as shown.
6. Perform the by-pass feed sensor paper size correction (
Adjustment - PAGE 10) as follows:
1) Enter SP mode (refer to Service Program Access Procedure) then
access
2) Place the side fence [C] at the A4 or 8
according to the paper size decal on the table.
3) Place the side fence [C] at the A6 or 4
according to the paper size decal on the table.
[C]
SP Adjustment - PAGE 10.
[B]
[B]
x 11 sideways position
1/2
x 5
1/2
1/2
5-80
15 July 1996
A176R641.wmf
SP
lengthwise position
Advertisement
Table of Contents
