Table of Contents
Advertisement
15 July 1996
1
SP ADJUSTMENT
PAGE 5
Item
Adjusts the lens position to correct
magnification in enlarge/reduce modes.
Adjusts the 3rd scanner home position to
correct the focus.
Factory use only
Adjusts the ADS sensor output to 2.7 ±
0.1 V while scanning the ADS pattern.
Adjusts the original stop position (thin
original mode) against the original side
scale in one-sided original mode
(0.5 mm/step).
Adjusts the original stop position against
the original side scale in two-sided
original mode (0.5 mm/step).
Adjust the original stop position (thick
original mode) against the original side
scale in one sided original mode
(0.5 mm/stop).
Adjust the gap between the 1st original
and 2nd original in combine 2 original
mode (1.3 mm/step).
A176M506.img
Function
4-11
SERVICE PROGRAM MODE
PAGE 6
Note
Input only the value marked on the lens.
Do not change the setting.
This mode is also performed during the
process control data initial setting.
Refer to page 46 of the DJF manual.
Refer to page 48 of the DJF manual.
A176M507.img
Advertisement
Table of Contents
