Table of Contents
Advertisement
TRANSFER BELT UNIT
5.3 CLEANING BLADE REPLACEMENT
[B]
[A]
[D]
[E]
1. Remove the transfer belt unit. (Refer to Transfer Belt Replacement.)
2. Remove the cleaning blade [A] and the small blade [B] (2 screws).
3. Clean the seals [C].
NOTE: When using a vacuum cleaner, to protect the transfer power pack
from static electricity, remove the power pack as follows:
1) Disconnect two connectors [D].
2) Remove the solenoid bracket [E] (2 screws).
3) While pushing the power pack toward the solenoid [F], release
the power pack from the hook [G].
4. Install the new cleaning blade.
NOTE: Do not touch the edge of the cleaning blade. If some of the
setting powder on the blade edge is removed, apply setting
powder or toner there.
1) Install the small blade [B] so that the front edge of the blade
contacts with the spring holder [H].
[H]
A176R610.wmf
[F]
[G]
[D]
A176R611.wmf
5-62
15 July 1996
[C]
A176R612.wmf
Advertisement
Table of Contents
