Table of Contents
Advertisement
15 July 1996
[C]
18. Install the rear bracket [A] (2 screws, 1 connector), shielding mylar
bracket [B] (1 screw) and harness cover [C] (2 screws).
19. Adjust the second scanner alignment as follows:
- Second Scanner Alignment -
1) Move the second scanner [D] to the left end position. Fix the rear side
of the second scanner by inserting the jig pin [E] in the holes on the
rear side of the second scanner and the rear guide rail.
2) Turn the adjusting nut [F] to adjust the second scanner alignment so
that the jig pins [G] can be smoothly set in the holes on the front side of
the second scanner and the front guide rail.
[B]
A176R546.wmf
[G]
[A]
[D]
5-29
OPTICS
[E]
[F]
A176R547.wmf
Advertisement
Table of Contents
