Table of Contents
Advertisement
PAPER FEED
[A]
[C]
A176R626.wmf
3) Paper feed timing adjustment for the by-pass feed station
1. Set two sheets of paper on the by-pass feed table [A].
2. Enter SP mode (refer to Service Program Access Procedure) and access
SP Adjustment - PAGE 2.
3. Touch the "Copy in SP" key [B].
4. Select the by-pass feed station.
5. Press the start key then when the paper stops for registration, mark the
trailing edge [C] of the paper on the next paper as shown.
6. Measure the distance [D] between the leading edge of the mark [E] and
the trailing edge of the paper [F] as shown. The adjustment standard is
106 ~ 115 mm.
7. Touch the "SP Mode" key.
8. Touch the – key [G] or the + key [H] to adjust the distance [D].
9. Touch the "Copy in SP" [B].
10. Repeat steps 5 to 9.
[E]
[F]
[D]
5-72
15 July 1996
[G]
[H]
A176R625-3.img
Advertisement
Table of Contents
