Table of Contents
Advertisement
SERVICE PROGRAM MODE
2
SP TEST MODE
PAGE 3
Item
Use to check if the original size sensors
are correctly activated and de-activated.
Use to check if the sensors or switches
are correctly activated and de-activated.
Access this mode as follows:
1. Touch the input mode key
2. Enter the sensor/switch/signal
number by using the number keys on
the operation panel. (Refer to the
input check mode on page 4-40.)
3. Touch the enter key
Use to check that the copier electrical
components are functioning properly.
Access this mode as follows:
1. Touch the output mode key
2. Enter the electrical component
number by using the number keys on
the operation panel (refer to the
output check mode on page 4-46).
3. Press the enter key
Operates the DF without copier operation. Procedure:
Operates the sorter stapler or finisher
without copier operation.
A176M520.img
Function
.
.
.
.
PAGE 4
Status 0 ------ de-activated (no paper)
Status 1 ------ activated (paper)
Status 0 ------ de-activated (no paper)
Status 1 ------ activated (paper)
Touch
touch
component.
1. Set originals on the table.
2. Touch
The sorter operates as if 3 copies are
made from five originals in sort and
staple mode. No stapling is actually done.
4-18
15 July 1996
A176M521.img
Note
to activate and
to de-activate the electrical
.
Advertisement
Table of Contents
