Table of Contents
Advertisement
FUSING UNIT
7.10 OIL SUPPLY/CLEANING ROLLER REPLACEMENT
[D]
[J]
[E]
1. Pull out the fusing unit.
2. Lower the lever [A].
3. Remove the oil supply unit [B].
4. Remove the upper entrance guide [C] (1 screw).
5. Remove the mylar bracket [D] (2 screws).
6. Remove the springs [E].
7. Remove the bushings [F].
8. Remove the oil supply roller [G], the oil supply cleaning blade [H] (3
screws), and the cleaning roller [I].
9. Install the new cleaning blade [H], cleaning roller [I] and oil supply roller
[G] then reassemble the unit.
NOTE: Install the cleaning blade [H], cleaning roller [I], oil supply roller
[G] and bushing [F]. Then, install the assembled parts to the
bracket [J].
[C]
A176R716.wmf
[A]
[E]
[B]
[F]
5-104
[G]
8 July 1996
A176R676.img
[F]
[I]
[H]
A176R717.wmf
Advertisement
Table of Contents
