Table of Contents
Advertisement
SERVICE PROGRAM MODE
2.4 ELECTRICAL COMPONENT CHECK (OUTPUT MODE)
NOTE: The motors keep turning in this mode regardless of the upper or
lower limit sensor signals. To prevent mechanical or electrical
damage, do not keep an electrical component on for a long time.
– How to check the sensor/switch/signal –
1. Enter SP mode as follows:
1) Press the mode clear key.
2) Enter "107".
3) Hold down the clear/stop key for more than 3 seconds.
2. Touch
to access SP Test mode.
3. Touch
twice.
[A] on the display
[A] on the display
[A]
4-46
15 July 1996
A176M570-2.img
[A]
A176M573.img
Advertisement
Table of Contents
