Table of Contents
Advertisement
2 Quick Start
2-13 Run the Application
In the Run view, you can observe the progress of the setup as it follows the parameters you have defined. The
right panel of the Run view shows Counts data for Cycles, Reads, No Reads, Mismatches, and Read %.
The right panel of the Run view also displays Rate data for Capture, Decode, Overhead, Total Read, and
Trigger Rate, followed by a Read Time graph and the Output Data area at the lower right of the interface.
The "filmstrip" at the bottom of the Run view shows the sequence of image captures with a
green check mark
for each Good Read and a
red x
for each No Read.
Refer to Section 5 – Run for a more detailed description of the Run interface.
Increase the magnification of this page to read the descriptions in the image below.
2-26
V440-F C-Mount Code Reader User Manual
Advertisement
Chapters
Table of Contents
