Omron V440-F User Manual page 43

2 Quick Start
2-4-3 V440-F DHCP Network Connection
1
If your PC is set to DHCP, you should set the reader to DCHP as well.
2
Plug your reader into your network adapter.
3
Run the Omron Device Discovery Utility (DDU).
4
Click Search to find the reader. When the reader appears, click on it to set parameters.
5
Turn DHCP On. Click Update Settings and Exit. The reader will reset and come up in DHCP
mode. The reader will then reboot and the DDU will search for the reader again.
6
When the reader is found, note the new IP address that is generated.
7
Open a browser and type the new IP address. WebLink will load.
Important: The reader does not work in APIPA mode. A DHCP server must be running on
the network to hand out IP addresses for this to function correctly. If a DHCP server is not
running on the network, the reader will continue to search for an IP address every 30 seconds.
2-4-4 Use the Device Discovery Utility (DDU) to Connect to WebLink
Omron provides the Device Discovery Utility (DDU) to enable automatic discovery and display of all
readers on the local network. You can use this utility to change reader settings, download software
updates to the camera, or launch the WebLink user interface.
You can establish a connection between WebLink and the reader with the Device Discovery Utility
(DDU), available at
Once you have downloaded the Device Discovery Utility .exe file from the website and installed it,
select Device Discovery Utility from your Start Menu.
The following screen will appear.
2-12
https://automation.omron.com or on your regional Omron website.
V440-F C-Mount Code Reader User Manual