Dotcode - Omron V440-F User Manual

Appendices
G-19 DotCode
Important: When DotCode is enabled, no other symbologies will be decodable. You must disable
DotCode to decode symbols of any other type.
G-19-1 DotCode Status
Serial Cmd:
Default:
Options:
Disabled
The reader will not attempt to decode DotCode symbols.
Enabled
The reader will attempt to decode DotCode symbols.
G-19-2 Rotation Mode
Serial Cmd:
Default:
Options:
No Rotation
The reader will decode horizontal and vertical symbols (+/– approximately 3 degrees).
Low Rotation
The reader will decode +/– approximately 10 degrees from the horizontal or vertical symbols. It is
slightly slower than the No Rotation option.
OmniDirectional
The reader will support 360 degree reading. Omnidirectional is significantly slower than the other two options.
G-19-3 Expected Rows
Definition:
Serial Cmd:
Default:
Options:
G-19-4 Expected Columns
Definition:
Serial Cmd:
Default:
Options:
G-30
<K497,status,rotation mode,expected rows,expected columns>
0 = Disabled
0 = Disabled
1 = Enabled
<K497,status,rotation mode,expected rows,expected columns>
0 = No Rotation
0 = No Rotation
1 = Low Rotation
2 = Omnidirectional
Expected Rows allows you to specify the exact number of rows in the code to minimize
the possibility of decoding errors and no reads. If you specify the exact row dimensions,
only DotCode symbols of the same dimensions are decoded.
<K497,status,rotation mode,expected rows,expected columns>
0
0 to 256
Expected Columns allows you to specify the exact number of columns in the code to
minimize the possibility of decoding errors and no reads. If you specify the exact column
dimensions, only DotCode symbols of the same dimensions are decoded.
<K497,status,rotation mode,expected rows,expected columns>
0
0 to 256
V440-F C-Mount Code Reader User Manual