Verifying Communications Over An Ip Lan - ADTRAN IQ 710 System Manual

VERIFYING COMMUNICATIONS OVER AN IP LAN

Introduction
When an Ethernet Port is connected to a local area network (LAN), test steps must be performed on the
IQ 710 to ensure that the unit is communicating properly over the network. This procedure outlines those
steps.
Prerequisite Procedures
Before beginning this procedure, the unit should be physically connected to the LAN and the provisioning
tasks detailed in DLP-004 should be complete.
Tools and Materials Required
• Access to a PC or other computer connected to the LAN
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, wear an antistatic discharge wrist strap to prevent damage to electronic
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
© 2002 ADTRAN, Inc.
61202800L1-1B
Section 5, Detail Level Procedures
IQ 710 System Manual
IQ 710
Page 95