ADTRAN IQ 710 System Manual page 279

3. Double click on the network configuration. The resulting screen is displayed in Figure 4.
4. Click on the Framing Format box. Choices of ESF, D4, and A
format that matches the framing on the Telco-provided T1 line. For this example, it is assumed all
three sites have ESF framing.
5. Click on the Line Coding box. Choices of B8ZS and AMI will appear. Select the line code that
matches the line code on the Telco-provided T1 line. For this example, it is assumed all three sites
have ESF framing. For this example, it is assumed all three sites have B8ZS coding.
6. Click on the RX Sensitivity box. Choices of N
ting is adequate for most applications. If the receive signal strength is less than 30 dB, choose
E . For this example, it is assumed all three sites have normal RX Sensitivity.
XTENDED
7. Click on the Line Build Out (LBO) box. Choices of 0 dB, 7.5 dB, 15 dB, 22.5 dB, and A
appear. The LBO should be selected based on the strength of the receive signal. For this example,
it is assumed all three sites have 0 dB LBO.
8. Click on the Channel Bandwidth box. Choices of
bandwidth that matches the channel bandwidth on the Telco-provided T1 line. For this example, it
is assumed all three sites have a x64 kbps bandwidth.
© 2002 ADTRAN, Inc.
Figure 4. Device>Config>Network Config Selections
Section 6, Configuration Guides
will appear. Select the framing
UTO
and E will appear. The N
ORMAL XTENDED
56 and 64
X KBPS X KBPS
61202800L1-1B
IQ 710
Page 279
set-
ORMAL
will
UTO
will appear. Select the
IQ 710 System Manual