ADTRAN IQ 710 System Manual page 266

61202800L1-1B
IQ 710
Section 6, Configuration Guides
Page 266
Huntsville IQ 710 (DCLI 600)
1. Using the left arrow, place the cursor over the number 2 (indicating entry 2) to the left of the DLCI
field; then press
2. Now add the DLCI to the Montgomery site. Use the right arrow to select DLCI; then press
Type in 600 and press
3. Use the right arrow to select DBU DLCI; then press
Notice that the TELCO-assigned DLCI of 600 for Huntsville's Frame Relay link to Montgomery is
programmed in the DLCI field. The TELCO-assigned DLCI of 500 for Montgomery's Frame
Relay link to Huntsville is programmed in the
proper dial backup operation.
4. Use the right arrow to select DBU P
press . The phone number that the Huntsville IQ 710 will dial to reach the Montgomery
<Enter>
IQ 710 to establish a dial backup connection has now been programmed.
5. Use the right arrow to select C
the table to be prioritized in the event that multiple PVCs are lost at once. Dial backup will first be
attempted on the PVC with the lowest Call Order that meets the DBU Criteria settings. Set this
Call Order to 2.
6. Use the right arrow to select DBU O
E ; then press
NABLED
IQ 710 System Manual
for insert. This should add an entry as shown in Figure 25.
<I>
Figure 25. New Entry Screen
.
<Enter>
HONE
O
ALL RDER
I
N NACTIVE
.
<Enter>
. Type in 500 and press
<Enter>
DBU DLCI field. These two entries are critical for
N ; then press
<Enter>
UMBER
. DBU C
N O
UMBER ALL RDER
; then press
<Enter>
<Enter>
<Enter>
. Type in 13345554000 and
allows each DLCI listed in
. Down arrow to select
© 2002 ADTRAN, Inc.
.
.