ADTRAN IQ 710 System Manual page 50

61202800L1-1B
IQ 710
Section 4, User Interface Guide
Page 50
If the IQ 710 encounters a PVC that has not been entered into the PVC O
the PVC is set to A
C >DSX P
ONFIGURATION
Set the frame format for the DSX-1 interface. These options are only available if a T1/DSX network inter-
face card is installed.
Choices: , and
D4, ESF
C >DSX P
ONFIGURATION
Set the line code for the DSX-1 interface. These options are only available if a T1/DSX network interface
card is installed.
Choices: AMI (alternate mark inversion) or B8ZS.
C >DSX P
ONFIGURATION
YEL ALARM enables and disables the transmitting of yellow alarms. These options are only available if
a T1/DSX network interface card is installed.
Choices: E , D
NABLE ISABLE
C >DSX P
ONFIGURATION
L L provides selection of the proper output level for the DSX-1 based on the length of the inter-
INE ENGTH
face cable. These options are only available if a T1/DSX network interface card is installed.
Choices: 1-133 , 133-266
FT
C >DSX P
ONFIGURATION
I L sets the DSX-1 to accept or reject in-band loopup or loopdown codes (per ANSI T1.403
NBAND OOPBACK
specification) which may be sent to the card over the DSX-1 interface. This loopback is a line loopback.
These options are only available if a T1/DSX network interface card is installed.
Choices:
A , R
CCEPT EJECT
C >DSX P
ONFIGURATION
This menu option is used to enable/disable robbed-bit signaling. Whenever the DSX-1 interface is con-
nected to terminal equipment (i.e., PBX/SW56) for voice or dialed data services, this option should be
enabled. The only exception is when the terminal equipment is using a form of common channel signaling
(i.e., PRI). These options are only available if a T1/DSX network interface card is installed.
Choices: E , D
NABLE ISABLE
C >D
ONFIGURATION IAL
The A DBU option specifies whether the unit automatically enters dial backup mode or waits
UTOMATIC
for manual setup. The factory default setting is D
installed.
IQ 710 System Manual
by default.
UTO
> F
ORT RAMING
.
A
UTO
> L C
ORT INE ODE
> Y A
ORT ELLOW
> L L
ORT INE ENGTH
, 266-399 , 399-533
FT FT
> I - L
ORT N BAND
> R B
ORT OBBED
B >A DBU
ACKUP UTO
F
ORMAT
LARM
, 533-655 , 7.5
FT FT
OOPBACK
S
IT IGNALING
. This option is only available with the DBU card
ISABLE
PTIONS
B
D
© 2002 ADTRAN, Inc.
table,