Craft/Control Port; Table 2. V.35 Winchester Pinout - ADTRAN IQ 710 System Manual

61202800L1-1B
IQ 710
Section 2, Engineering Guidelines
Page 24
Pin CCITT
A 101
B 102
C 105
D 106
E 107
F 109
H —
J —
R 104
T 104
V 115
X 115
P 103
S 103
Y 114
AA 114
U 113
W 113
NN —

Craft/Control Port

The Craft/Control port (EIA-232) connects to a computer or modem or to a VT-100 terminal. The Craft/
Control port input provides the following functions:
• Accepts EIA-232 input from a PC or a modem for controlling the IQ 710.
• Operates at 9600, 19200, 38400, or 57600 bps.
• Acts as input for either VT-100 terminal or PC control.
• Acts as an interface for flash memory software downloads using XMODEM.
The Craft/Control connection follows, and Table 3 shows the pinout.
Connector type
Part number
IQ 710 System Manual

Table 2. V.35 Winchester Pinout

Protective ground (PG)
Signal ground (SG)
Request to send (RTS) from DTE
Clear to send (CTS) to DTE
Data set ready (DSR) to DTE
Received line signal detector (DCD) to DTE
Data terminal ready (DTR) from DTE
Ring indicator (RI)
Received data (RD-A) to DTE
Received data (RD-B) to DTE
RX clock (RC-A) to DTE
RX clock (RC-B) to DTE
Transmitted data (TD-A) from DTE
Transmitted data (TD-B) from DTE
TX clock (TC-A) to DTE
TX clock (TC-B) to DTE
External TX clock (ETC-A) from DTE
External TX clock (ETC-B) from DTE
Test mode (TM) to DTE
DB-9C
KYCON# K22-E9S-N or RDI#
DR-E9S-N-601A
DESCRIPTION
© 2002 ADTRAN, Inc.