ADTRAN IQ 710 System Manual page 54

61202800L1-1B
IQ 710
Section 4, User Interface Guide
Page 54
C >D
ONFIGURATION IAL
This option is only available with the BRI ISDN DBU card installed.
- Select which type of telco switch is providing the ISDN service. There are four
S T
WITCH YPE
options for ISDN switch types:
• L 5ESS
UCENT
• DMS100
• N
ATIONAL
• NEC
B-C B R
HANNEL IT ATE
vice only provides 56k.
N B-C
UMBER OF HANNELS
if bonding is used. This option is not available when a 56k/64k network interface card is installed.
SPID 1 and SPID 2
sequence of digits identifying ISDN terminal equipment to the ISDN switch when more than one
ISDN set has been attached to the same central office line. The SPID is assigned by the telco when
the ISDN line is installed and normally resembles the phone number.
Only the Lucent 5ESS switch is capable of recognizing a point-to-point configuration, eliminating
the need for a SPID. All other switch types require a SPID.
The option is not available when a 56k/64k network interface card is installed.
SPID 2
LDN 1 LDN 2 -
AND
the ISDN line is installed. The
installed.
C >D
ONFIGURATION IAL
If C S is set to E
ALL CREENING
entered in the N
UMBER
able number are rejected (for BRI card only). This option only available with BRI ISDN DBU Module
installed.
IQ 710 System Manual
B >ISDN O
ACKUP
- Select the channel bit rate for the ISDN service. Select 64k unless your ser-
Select the number of B-channels supported by the ISDN service. Select 2
-
- Enter the service profile identifier (SPID) for both B-channels. The SPID is a
Enter the LDNs for both B-channels. The LDNs are assigned by the telco when
option is not available when a 56/64K network interface card is
LDN 2
B >C S
ACKUP ALL CREENING
, the IQ 710 will only accept incoming calls from the numbers
NABLE
1 through N 5 fields. Calls from any other number or from an unidentifi-
UMBER
PTIONS
© 2002 ADTRAN, Inc.