ADTRAN IQ 710 System Manual page 49

DBU O I option to have an affect on auto DBU operation, the W
N NACTIVE
be set to E .
NABLE
If DBU I is set for E
ON NACTIVE
or unknown state, the IQ 710 will dial the phone number designated by the DBU
in the table entry.
G
is a special case in which all PVCs that are part of a group must be in an inactive or unknown state
ROUP
before the auto DBU process is triggered. This special case is treated as a port failure in which the DBU
C O
entry applies.
ALL RDER
These options are only available if a DBU card is installed. However, they are not available with the DCE
DBU card installed.
C >N
ONFIGURATION ETWORK
Enter the CIR (committed information rate) in kbps for the corresponding DLCI. The information is pro-
vided by your service provider and must be entered for each PVC.
C >N
ONFIGURATION ETWORK
Set to E only if there is an IQ or ATLAS product on the other end of the PVC. When enabled, the IQ
NABLE
710 tags each frame with a sequence number which is then used by the remote IQ or ATLAS unit to detect
lost packets. Lost packet counts are given in the S
C >N
ONFIGURATION ETWORK
Set to E
only if there is an IQ or ATLAS product on the other end of the PVC. When enabled, the IQ
NABLE
710 periodically transmits a loopback frame to the remote IQ or ATLAS unit which is then returned to
measure round trip delay of each PVC. Minimum, maximum, and average delay measurements are given
in the S
menus.
TATISTICS
C >N
ONFIGURATION ETWORK
This option prioritizes PVCs for S
the PVCs that pass through. This number is determined in the M
for this field are described below:
If set to
A - A
UTO UTO
exceeded. The
A
UTO
E - If set to
NABLED
not been exceeded. A PVC set to
D - If set to
ISABLED
© 2002 ADTRAN, Inc.
and the PVC designated by the DLCI element goes to an inactive
NABLED
P >PVC O
ORT
P >PVC O
ORT
P >PVC O
ORT
P >PVC O
ORT
counts. The IQ 710 tracks statistics for a limited number of
TATISTICS
, then statistics will be logged for this PVC if the
selection designates a PVC as second priority to a PVC set to
E , then statistics will be logged for this PVC if the
NABLED
E
NABLED
D , then statistics will not be logged for this PVC at any time.
ISABLED
> CIR (K
PTIONS BPS
> S N
PTIONS EQ UM
menus.
TATISTICS
> D M
PTIONS ELAY EASUREMENT
> S O
PTIONS TATS PTION
PVC C
AX
is designated as a higher priority than one set to
61202800L1-1B
Section 4, User Interface Guide
PVC I option must
ITH NACTIVE
PHONE NUMBER
)
C
HECKING
field. The three choices
OUNT
has not been
M PVC C
AX OUNT
E
NABLED
M PVC C
AX
IQ 710 System Manual
IQ 710
Page 49
element
.
has
OUNT
.
A
UTO