Connecting The Terminal Or Pc To The Craft/Control Port - ADTRAN IQ 710 System Manual

CONNECTING THE TERMINAL OR PC TO THE CRAFT/CONTROL PORT

Introduction
IQ 710 management and provisioning is facilitated by a series of intuitive menus that are accessible on a
computer screen. Connecting either a VT-100 terminal or a PC emulating a VT-100 terminal to the
C port on the rear of the unit allows access to the menus and management features of the IQ 710.
ONTROL
This section specifies how to connect the VT-100 terminal or PC to the IQ 710.
Prerequisite Procedures
The IQ 710 must be powered for terminal communication to function.
Tools and Materials Required
• Male-to-female DB-9 cable (customer-provided) to connect to a VT-100 terminal or a PC configured
as a VT-100 terminal
• VT-100 compatible terminal or computer with terminal emulation software
• DB-9 to DB-25 adapter if the PC's com port is DB-25 (customer-provided)
© 2002 ADTRAN, Inc.
61202800L1-1B
Section 5, Detail Level Procedures
IQ 710 System Manual
IQ 710
Page 83
C /
RAFT