ADTRAN IQ 710 System Manual page 267

Huntsville IQ 710 (DLCI 800)
1. Using the left arrow, place the cursor over the number 3 (indicating entry 3) to the left of the DLCI
field; then press
2. Now add the DLCI to the Mobile site. Use the right arrow to select DLCI; then press
in 800 and press
3. Use the right arrow to select DBU DLCI; then press
Notice that the TELCO-assigned DLCI of 800 for Huntsville's Frame Relay link to Mobile is pro-
grammed in the DLCI field. The TELCO-assigned DLCI of 700 for Mobile's Frame Relay link to
Huntsville is programmed in the
backup operation.
4. Use the right arrow to select DBU P
press . The phone number that the Huntsville IQ 710 will dial to reach the Mobile
<Enter>
IQ 710 to establish a dial backup connection has now been programmed.
5. Use the right arrow to select C
the table to be prioritized in the event that multiple PVCs are lost at once. Dial backup will first be
attempted on the PVC with the lowest Call Order that meets the DBU Criteria settings. Set this
Call Order to 4.
6. Use the right arrow to select DBU O
E ; then press
NABLED
© 2002 ADTRAN, Inc.
for insert. This should add an entry as shown in Figure 26.
<I>
Figure 26. New Entry Screen
.
<Enter>
DBU DLCI
HONE
O
ALL RDER
I
N NACTIVE
.
<Enter>
. Type in 700 and press
<Enter>
field. These two entries are critical for proper dial
N ; then press
<Enter>
UMBER
N . DBU C O
UMBER ALL RDER
; then press
<Enter>
61202800L1-1B
Section 6, Configuration Guides
Page 267
<Enter>
<Enter>
. Type in 13345555000 and
allows each DLCI listed in
. Down arrow to select
IQ 710 System Manual
IQ 710
. Type
.