ADTRAN IQ 710 System Manual page 44

61202800L1-1B
IQ 710
Section 4, User Interface Guide
Page 44
C >DTE P
ONFIGURATION
If this option is set to E
router. Enable this option when the management DLCI is used to route management traffic to the IQ 710.
Options are E and D
NABLED
C >DTE P
ONFIGURATION
This option determines when PVC
If enabled, PVC
A O -
LWAYS N
signaling state. Enable this option when the IQ 710 is used for dial backup.
F N
OLLOW ETWORK
only when the network signaling state is up. Enable this option when the router is going to use an
alternate path for dial backup.
If enabled, PVC signaling responses are NOT sent to the router, regardless of the net-
A O -
LWAYS FF
work signaling state. Enable this option to simulate a PVC failure when the router is going to use an
alternate path for dial backup.
C >N
ONFIGURATION ETWORK
- This field allows the user to map each individual DS0 to the DSX-1 port or to the
C M
HANNEL AP
DTE port, or to set it to idle.
DS0 . . . DS024
- Set the frame format for the network interface.
F F
RAMING ORMAT
Choices: , and
D4, ESF
D4 is equivalent to superframe format (SF).
L C - Set the line code for the network interface.
INE ODE
Choices: AMI (alternate mark inversion) or B8ZS.
C S - Select the clock source to be derived from the network or from the unit's internal
LOCK OURCE
clock. The selected clocking option designates the clock source for transmission. Clocking necessary
for receiving data is recovered from incoming data. This option is most commonly set to
.
WORK
Choices:
I
NTERNAL
L B (LBO) -
INE UILDOUT
sets the LBO based on the strength of the receive signal. Options:
IQ 710 System Manual
>F R
ORT RAME ELAY
, the management DLCI is included in the Full Status response to the
NABLED
.
ISABLED
>F R
ORT RAME ELAY
S R
IGNALING
S R
IGNALING
If enabled, PVC
(FOLLOW NET) -
P >P
ORT HYSICAL
- Listing of individual DS0s in the Channel Map.
.
A
UTO
and .
F N
ROM ETWORK
Select the line buildout for the network interface. In
O >M
PTIONS ANAGEMENT
O >S
PTIONS IGNALING
are sent to the router.
ESPONSES
are sent to the router regardless of the network
ESPONSES
S R
IGNALING
L O
AYER PTIONS
PVC O
PTION
R
ESPONSES
are sent to the router
ESPONSES
>T1 DSX C
ARD
F
mode, the IQ 710
A
UTO
, and
A , 0, 7.5, 15 22.5
UTO
© 2002 ADTRAN, Inc.
N -
ROM ET
.
B
D