ADTRAN IQ 710 System Manual page 96

61202800L1-1B
IQ 710
Section 5, Detail Level Procedures
Page 96
Perform Steps Below in the Order Listed
1. Ascertain the IQ 710 IP address.
If you do not already have the IP Address for the IQ 710, either obtain it from the network admin-
istrator or manually check for the address in the
Network Management interface.
2. Ping the IQ 710 unit from a remote computer on the network.
Using a remote computer system connected to the LAN, perform an ICMP Ping on the IP Address
of the IQ 710. Verify that the unit responds properly.
If the IQ 710 fails to respond, try the following:
• Verify that the proper IP Address, Subnet Mask, and
the unit (see DLP-004 for details).
• Verify that the IQ 710 is properly cabled into the LAN and that the ethernet cable is properly
seated in the RJ-45 jack on the rear of the unit.
• If the IQ 710 is connected to a hub or other network device that provides a carrier sense light
for each port, verify that the carrier sense light for the port to which the IQ 710 is connected is
lit. If this light is not lit, check the cabling between the hub and the shelf.
• Verify the IP Address, Subnet Mask, and Default Gateway on the remote computer system.
If none of these steps are successful, contact the LAN Administrator for assistance.
Refer to the documentation of the computer system if you are unsure how to perform a
Ping command. Most computers running a networked version of Microsoft Windows™ or
UNIX allow a Ping to be performed by simply typing
line prompt. Typically, the Ping program will respond by indicating that the remote IP
Address has responded in a certain amount of time or that no response was received.
Some versions of Ping will continue running until you explicitly tell them to stop. If the
program does not terminate on its own, type
IQ 710 System Manual
DLP-005
C
ONFIGURATION
G
ATEWAY
"ping <IP Address>"
to get the program to stop.
<Ctrl+C>
/S /IP A menu of the
YSTEM DDRESS
IP A are provisioned in
DDRESS
at a command
© 2002 ADTRAN, Inc.