Dlp-4 Verifying Communications Over An Ip Lan - ADTRAN ATLAS 800 SERIES System Manual

DLP-4 Verifying Communications Over an IP LAN

Introduction
This procedure outlines the steps for testing the ATLAS, when its Ethernet port is connected to a local area
network (LAN). Testing ensures that the unit is communicating properly over the network.
Prerequisite Procedures
Before beginning this procedure, the unit should be physically connected to the LAN and all provisioning
tasks should be complete (see DLP-3,
Tools and Materials Required
Access to a PC or other computer connected to the LAN
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, wear an antistatic discharge wrist strap to prevent damage to electronic
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
61200780L1-1C
Setting IP Parameters for the ATLAS 800 Series System,
© 2004 ADTRAN, Inc.
on page 322).
324