ADTRAN IQ 710 System Manual page 90

61202800L1-1B
IQ 710
Section 5, Detail Level Procedures
Page 90
Perform Steps Below in the Order Listed
1. Mount the modem in its permanent position.
2. Connect power to the modem using manufacturer instructions.
3. Configure the modem as follows:
Speed
Data bits
Parity
Stop bits
Flow control
Auto answer
DTR
4. Connect the male DB-9 connector of the modem cable to the female DB-9 connector, labeled
C , located on the back of the unit.
RAFT
5. Connect the DB-25 end of the modem cable to the modem, configured as described above.
6. Connect the modem to the POTS line as required by the manufacturer.
To complete the modem connection, the IQ 710 must now be called from a PC that is
configured to emulate a VT-100 terminal, with communication software set as in step 3
and configured for dial mode.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
IQ 710 System Manual
DLP-003
9600 bps
8
none
1
hardware
on
ignore
© 2002 ADTRAN, Inc.