ADTRAN IQ 710 System Manual page 166

61202800L1-1B
IQ 710
Section 6, Configuration Guides
Page 166
Atlanta IQ 710 (DLCI 20)
1. From the C
ONFIGURE
then press
<Enter>
nication with Huntsville.
You can verify the correct DLCI by looking for the active DLCI in the DLCI list.
2. Use the right arrow to select DBU DLCI; then press
the DLCI that the Huntsville IQ 710 uses to communicate with Atlanta.
3. Use the right arrow to select DBU P
press . The phone number that the Atlanta IQ 710 will dial to reach the Huntsville IQ 710 to
<Enter>
establish a dial backup connection has now been programmed.
4. Use the right arrow to select DBU
E ; then press
NABLED
in the event that DLCI 20 is advertised as Inactive by the Frame Relay switch.
Since there is only one PVC for Atlanta, there is no need to enter another entry into the PVC table.
At this point the Atlanta IQ 710 is configured for basic dial backup to Huntsville. The
PVC O screen is shown in Figure 21. The vertical screen shown can be achieved by placing
PTIONS
the cursor over the number 1 (indicating entry 1) to the left of the
IQ 710 System Manual
Figure 20. Huntsville IQ 710 (DLCI 17) Screen
PVC O screen shown in Figure 17, use the right arrow to select DLCI;
PTIONS
. Type in 20 and press
<Enter>
N
HONE
I
ON NACTIVE
. This allows the Atlanta IQ 710 to dial out to the IQ 710 in Huntsville
<Enter>
. This is the DLCI that Atlanta uses for commu-
. Type in 16 and press
<Enter>
; then press
<Enter>
UMBER
; then press
<Enter>
DLCI
<Enter>
. Type in 12565551000 and
. Down arrow to select
C
ONFIGURE
field and pressing
© 2002 ADTRAN, Inc.
. This is
.
<Enter>